Cofer's heavy duty rear splitting stand weighs 400. It will adjust
from 13" in the low position to 35" in the hight position using the
reversible bracket furnished (the bracket has V-shaped or straight side).
The draw bar or back portion of this rear splitting stand will adjust from
13" to 28". Its large 6" casters and heavy duty construction makes this
the one to do all the big or little jobs. The HR-16's adjustable draw bar
support fits all tractors, 2 wheel or 4 wheel drive. This stand can also
be use as a handy work bench. After splitting the tractor, roll the rear
end over to the wash rack then back to your work bench for easy dismantling
and reassembly. It will jack up the rear end of any tractor still assembled
with cab, dual tires, etc. Cofer's rear stand stores easily on end.
Cofer's heavy duty front splitting stand weighs 320 and will adjust
from 18 1/2" in the low position to 52" in the high position. It has 6"
casters for easy rolling. HF-15 is sturdy. Built from heavy gauge material,
it will handle those big tractors. It fits all tractors, frame or frameless,
2 or 4 wheel drive. In most cases there are no bolts or jacks to adjust,
but they can be used when needed. The stand installs in 2 minutes with no
lifting. It has easy to use telescoping adjustments, two hydraulic jack
adjustments and allthread adjustments. You don't waste time taking front
weights or fuel tanks off. The stand supports under the front axle or
under the weight rack without having to take them off or put them back on.
With a HF-15 you can roll the tractor ahead, and don't need to take anything
off the frame to let the stand work. Stands on end for easy storage when
not saving you time around the shop.
R-12 weighs in at 300 lbs. and has large 6" casters and heavy
construction that makes it the one to do all the big or little jobs. Its
adjustable draw bar support will support all tractors. Use this stand
with or without a jack on the rear end of all tractors. It also can be
used as a handy work bench when stripping the rear case down. When rear
case is stripped, roll the stand over to the wash rack, and when finished,
roll it up by your bench for easy repair work. Its simple telescoping
adjustment make for quick installation on a clutch job or a complete
overhaul. The R-12 will work on a 2-wheel or 4-wheel drive tractor.
This stand converts into a frontstand for clutch work. It's a sturdy
double duty stand and for easy storage it will stand on end. Remember
our 60 day money back guarantee.
Equipped with 6" casters for an easy roll, F-11 weighs in at 200 lbs. Built from heavy gauge
steel to handle up to 8,000 lbs. This stand fits all tractors, frame or
frameless. In most cases, there are NO bolts to fool with, but
they can be used when needed. The F-11 installs in two minutes with no
lifting. There is no need to waste time taking front weights or fuel tanks
off the tractor. It can provide support under the front axle or under the
weight rack without wasting time to take them off or put them back on. It
allows you to roll the tractor ahead. On framed tractors, you do not have
to take anything off the frame for the stand to work. Just think how much
time can be saved on weight racks, sprayer tanks, lift or bucket brackets,
tool boxes, batteries and many extras. This stand will work on 4-wheel
drive tractors also. It stands on end for easy storage when not in use.
Try one. With our money back guarantee you have everything to gain and
nothing to lose.
Seen what you want? Contact us.
OR
check out our other equipment
